WinCT-UFC
pour FC-i/Si, AD-4405/06/07
ATTENTION :
Ce logiciel, sa notice et son accord de licence ne sont disponibles qu'en
langue Anglaise.
WinCT-UFC for
FC-i/Si, HC-i, AD-4405/06/07 |
"WinCT-UFC"
(Windows Communication Tools for UFC) is an "Windows Data Communication
Software" application to enable a computer and an instrument/ instruments to
communicate interactively with each other in order to utilize the UFC
functions of the weighing instruments of A&D brand.
Caution
Before setting up "WinCT-UFC", back up important data on the computer for
your own safety. UFC functions differ depending on each weighing instrument.
Refer to the instruction manual of the weighing instrument in use for format
or reply of communication. Refer to the manufacturer about computers or
software other than "WinCT-UFC".
License Agreement
------------------------------------------------------------------------------
It is prohibited to reproduce "WinCT-UFC" without our prior written consent.
Specifications of "WinCT-UFC" are subject to change without notice.
The copyright of "WinCT-UFC" is owned by A&D Company, Limited.
"WinCT-UFC" is to be used for data transmission between A&D's weighing
instrument and a computer.
"WinCT-UFC" can only be installed and used on the hard disks or other
storage device of the computer
to be connected to the weighing instrument.
Codemes SAS and A&D Company, Limited assume no liability at all for direct
or indirect andparticular or inevitable damages due to
defects of "WinCT-UFC" or this "Readme" even though possibility of
occurrence of such damages has been notified.
Further, Codemes SAS and A&D assume no liability for claims of rights from
third parties. At the same time A&D assumes no liability
at all for software or data losses.
Microsoft and
Windows are registered trademarks or trademarks of Microsoft Corporation in
the United States and other countries
Setting the
weighing instrument
------------------------------------------------------------------------------
Refer to the instruction manual of the weighing instrument in use for the
details of communication setting and data output setting of the weighing
instrument. Specify the mode of the weighing instrument to receive command.
Example
Factory setting for AD-4405, AD-4406, AD-4407, FC-i Series and HC-i Series.
The set value will be used in the explanation below.
Communication
Setting Item Factory Setting
Baud Rate 2400 baud
Parity EVEN (even number)
Bit Length 7 bits length
Stop Bit 1 bit length
Terminator CR/LF
Handling Instructions on WinCT-UFC
------------------------------------------------------------------------------
1. Introduction
------------------------------------------------------------------------------
With this software, data can be transmitted/received via RS-232C between
A&D's weighing instrument and a computer, and data transmitted/received can
be saved and read in text file. Transmission of data is performed by each
line. This is suitable for setting ofUFC functions of A&D's weighing
instrument since a long sentence can be transmitted by one operation.
2. Features of WinCT-UFC
------------------------------------------------------------------------------
Data can be transmitted and received via RS-232C between a weighing
instrument and a computer.
The result transmitted/received can be displayed on the computer screen and
saved in text file. Printing is also possible.
-Data transmitted can be read in text file.
Text will be transmitted by each line and the transmission interval can be
set.
When multiple weighing instruments were connected to each port of a
computer, it is possible to communicate with each weighing instrument at the
same time.
(Multiple execution)
-It is possible to operate with the other applications at the same time. (It
does not occupy the computer.)
Computer OS
Microsoft Windows 95/98/Me/2000/XP
CPU Pentium II 300MHz or faster
RAM 12MB or more recommended
Hard Disk 10MB minimum free space on hard disk
CRT VGA or higher resolution monitor
Other RS-232C port
Download :
WinCT-UFC 1.8MB ZIP file
|